problem calibrating reloop spin!+

[barryh1234]

Im having trouble with Spin!+, all the hardware is set up as instructed and im following the steps in the installation but its not working for me it comes up with the follwing error

Spin! has not been calibrated properly

Check connections and hardware setup

Can some one please help me with this?? evrything is as it should be and im puzzled as to why its not working

Thanks Barry

[DJ Synapse]

When using timecode vinyl
Before you go into the easy setup as described in the setup instructions.
First you must set the timecode manually (not mentioned at all in setup manual)
Set pitch to 0 on decks
Go to File>Options and click the timecode tab
You will see that source one is set to something like +96db.. (which as you can imagin causes some interesting problems and makes your signal quality 0%) click the "calibrate" button under the sine wave display for deck 1 this will will bring it to near where you need it to be for the software but still too high.. adjust upper and lower limits until the meter is in the middle of the green "VU" meter.. leave it for about a minute or until you see 100% signal quality.. deck 2 will be better but not perfect so repeat for deck 2
Then you can run easy setup without getting the no source signal error. You can find the easy setup in one of the other menus sorry forget which (think it is the last on the right).

[Reloop_Dave]

Thanks for that! *CLOSE TOPIC*