10tion - BIG problem when making macbook sleep, then wakeup.

[jbainesy]

Hello!
I've been using the 10tion for a few months now and have the following main problem:

(Note - I often setup 100%, make my macbook 'sleep' then 'wake up' just before performing with (hopefully) minimum setup after waking up!)

I wake up my macbook (13.3", 2.26GHz, unibody model, OSX Snow Leopard, Ableton Live 8.1.3) and HAVE to disconnect / reconnect the 10tion. There is no audio output if I do not do this to 're-initialise' the unit.

I usually work with 48,000Hz sample frequency, but I notice that sometimes when I connect the 10tion, it connects at a different sample rate and unless I realise and disconnect/reconnect it AGAIN, the sound output is all warped because the sample rates do not match!

What can be done? this is obviously a problem with the 10tion or it's drivers, it's not a problem when using onboard sound or other sound cards because they don't require the disconnect/reconnect to 'reboot' them, they simply work.

What can be done? This is a big flaw. I don't mean to be rude, but honestly, this card makes ME look bad, like I don't know how to connect or setup my gear properly - Please, any help would be appreciated!!! any other users having the same problem please take the time to post as if it is a common problem reloop need to know!

Regards,
Jarred Baines

[Reloop_Tutor]

try to deinstall the driver an install again.

[jbainesy]

I'm new to mac, but have learnt a lot! But I am still not 100% SURE how to remove the driver (infact, from memory there is no driver for mac, just the java app which controls volume) Is this correct? if not, could you or someone give me step by step instructions?

Thanks though, I will look into this, but at this stage, not sure how to successfully do it on my mac ;-)

Cheers,
Jarred