Instruction for upgrading the firmware (Interface Edition)

[Reloop_Specialist]

Instruction for upgrading the firmware

The newest firmware is: V13 / CONTOUR_IF_V13.bin (attached)

Supported Traktor versions

• Traktor Pro 2 V2.0.2 and higher
• Traktor LE V1.2.7 and higher

Start Update mode of your Reloop Contour
It's very important that your Reloop device is connected correctly to your computer.

• Now power OFF the Reloop device if not already done.
• Press and Hold the "CUE" button at the bottom and power it ON.
• The CUE button should light up. You can release the CUE button.

Update Application
Start the attached Java application UsbUpgDataApp_V*.jar.

Select your Reloop Contour
Just open the window Select Midi Device and find the entry Reloop Contour.

Firmware Update
1) Choose the correct firmware for your Reloop Contour in the download pool.
Be sure that it is the correct firmware, otherwise it might damage your device.

2) Press Start to start updating your Reloop device.

Finish
When the update was successful, you should see the following message: “Update Success!!!�


Importing a mapping into Traktor (Scratch) Pro 2
 
Before starting Traktor, the Contour should be connected to your computer and should also be installed correctly.

1. Start Traktor and open the settings.
2. Open "Controller Manager" and click on Add..>Import.

Note: If you find an older Contour mapping in the list, you have to delete it first! Just choose the mapping, click "Edit...", then "Delete".

3. Using the file dialog, choose the newly downloaded mapping file.

Now the mapping file should be loaded correctly. Have a look at the screenshot how it should look like.